ino/mcopy_JKMM100/mcopy_JKMM100.ino

@@ -65,6 +65,8 @@ McopySerial mc(McopySerial::PROJECTOR_IDENTIFIER);
 void setup () {
   mc.begin();
   pins();
+  proj_dir = false;
+  cmdChar = 'p';
 }
 
 void loop () {
@@ -73,7 +75,7 @@ void loop () {
   if (proj_running) {
     proj_microswitch();
   } else {
-    cmdChar = mc.loop();
+    //cmdChar = mc.loop();
     cmd(cmdChar);
   }
 }
@@ -83,8 +85,8 @@ void pins () {
   pinMode(PROJECTOR_FWD, OUTPUT);
   pinMode(PROJECTOR_BWD, OUTPUT);
 
-  digitalWrite(PROJECTOR_FWD, LOW);
-  digitalWrite(PROJECTOR_BWD, LOW);
+  digitalWrite(PROJECTOR_FWD, HIGH);
+  digitalWrite(PROJECTOR_BWD, HIGH);
 }
 
 void cmd (char val) {
@@ -103,9 +105,9 @@ void proj_start () {
   proj_time = millis();
 
   if (proj_dir) {
-    digitalWrite(PROJECTOR_FWD, HIGH);
+    digitalWrite(PROJECTOR_FWD, LOW);
   } else {
-    digitalWrite(PROJECTOR_BWD, HIGH);
+    digitalWrite(PROJECTOR_BWD, LOW);
   }
   
   proj_running = true;
@@ -114,8 +116,8 @@ void proj_start () {
 void proj_stop () {
   //stop both directions
   delay(10);
-  digitalWrite(PROJECTOR_FWD, LOW);
-  digitalWrite(PROJECTOR_BWD, LOW);
+  digitalWrite(PROJECTOR_FWD, HIGH);
+  digitalWrite(PROJECTOR_BWD, HIGH);
 
   mc.confirm(McopySerial::PROJECTOR);
   mc.log("projector()");

scad/jk.scad

@@ -1,34 +0,0 @@
-/*
-	JK modules
-
-	Directional switch connector =
-	Philmore
-	Mobile Connector
-	Panel Mount 3 Pin Male/Female
-	No. 61-623
-	.625" Diameter
-
-*/
-
-
-
-module jk_male_connector_mount () {
-	$fn = 200;
-	D = 17;
-	OD = 28;
-	H = 25;
-
-	difference () {
-		union () {
-			cylinder(r = OD / 2, h = H, center = true);
-			//cube([12, 48, 3], center = true);
-		}
-		//main void
-		translate([0, 0, -3]) cylinder(r = (OD / 2) - 3, h = H, center = true);
-		//connector void
-		cylinder(r = D / 2, h = H * 2, center = true);
-	}
-
-}
-
-rotate([180, 0, 0]) jk_male_connector_mount();

scad/mcopy_projector.scad

@@ -0,0 +1,21 @@
+include <./common/common.scad>;
+
+PART = "debug";
+
+module debug () {
+	cube();
+}
+
+module projector () {
+	
+}
+
+module key () {
+	
+}
+
+if (PART == "projector") {
+	
+} else {
+	debug();
+}