3.3 KiB
INTVAL3
What is this?
INTVAL3 is an open source intervalometer for the Bolex 16mm camera. The goal of the project is to create a cheap-to-make intervalometer that can be used to automate time-lapse or animation on the Bolex using mobile, web or physical controls.
This is the third incarnation of the INTVAL project, this time utilizing the Raspberry Pi Zero W for Wifi and Bluetooth control. Earlier versions, the INTVAL and INTVAL2 were Arduino-based. The original INTVAL used a solenoid (!!!) to hammer a camera release cable, while the second attempt was a proving ground for the motor-and-key hardware used in this version.
The INTVAL2 project should be used if you prefer a simpler, physical interface approach.
Components
- Firmware for the Raspberry Pi Zero W running Node.js on Raspian
- Mobile app for controlling device using Cordova + Bleno
- Web app for controlling device using Restify
- Hardware files, parts models for 3D printing, laser cutting and CNC
- PCB design for a Raspberry Pi Zero W Bonnet
- Parts list
Firmware
The firmware of the INTVAL3 is a node.js application running on the Raspian OS intended for installation on the Raspberry Pi Zero W.
Mobile App
The INTVAL3 mobile app controls the intervalometer over Bluetooth. It can be used to configure the settings on the intervalometer such as exposure length, delay between frames and the direction of the film. The app can also be used to trigger individual frames, as well as start and stop sequences. As an experimental feature, film exposure settings can be determined with the camera on a mobile device.
Web App
As a function of the firmware, there is an embedded web application that is hosted on the INTVAL3. When connected to a wifi network (via the mobile app) users are able to control the intervalometer from a browser. Users are also able to trigger functions and change settings on the intervalometer firmware from the command line by using cURL or wget, so actions can be scripted and automated from an external machine.
Hardware
All of the non-electronic hardware is generated from OpenSCAD scripts and built into either STL files for 3D printing or DXF files for laser cutting or CNCing.
Electronics designs are available in the form of a Fritzing file, a wiring diagram and a mask image that can be used to fabricate a board from a blank PCB. One of the easiest ways to